AudioControl The Epicenter Micro Bass restoration processor and line output conv

Description: AudioControl The Epicenter® Micro Bass restoration processor and line output converter Add bass to your aftermarket system's high-level sourceMost factory radios dial down deep, low-hitting bass notes to protect flimsy factory speakers. The Epicenter Micro from AudioControl takes amplified speaker-level signals, converts them into the high-quality preamp signals your sub amp needs, and then adds the bass that's missing. Even when listening to traditionally bass-weak classical, jazz, folk, or Tejano music, you'll finally be able to hear all the good bass you've been missing How does it do it? Sophisticated processing analyzes the incoming signal and synthesizes low-bass fundamental tones, increasing bass response tremendously. A single band ParaBASS® equalizer lets you fine-tune your subwoofer's tone. A selectable subsonic filter removes extreme low frequencies so your amps and subs will play more efficiently. The Epicenter Micro will also connect to any receiver with preamp outputs — its balanced inputs will reject noise from your car's electrical system for ultra-clean output. Installation conveniences The included ACR-4 dash-mount wired remote control allows you to adjust the level of your sub channel on the go. Load selection switches make OEM factory system integration easier, so The Epicenter Micro will work with almost any vehicle's sound system. Selectable turn-on modes include GTO™ Signal Sense (DC offset), audio sigal , or remote 12-volt input. Product highlights: active 2-channel line driver/output converter with bass restoration designed to work with aftermarket and factory systems provides up to 9.5 Vrms output (selectable level: 5, 7, 10V) preamp and speaker-level inputs speaker-level inputs handle up to 40V (400 watts RMS) speaker-level inputs feature switchable load resistance (20, 60, or 20,000 ohms) to prevent factory stereo shut-down Epicenter bass restoration increases bass response Para-Bass controls adjust center-frequency and width of bass EQ processing More info: ACR-4 wired remote included switchable Programmable Frequency Match (PFM) subsonic filter (20 Hz, 12/dB octave) selectable ground isolation helps eliminate noise auto turn-on via 12V remote, DC offset, or audio signal detect 12-volt turn-on lead output wiring, fuse, and hardware not included with device 18-gauge power and ground leads and a 1-amp fuse recommended dimensions: 5-1/8" W x 1" H x 3" D warranty: 5 years ⚠️Warning: Cancer and Reproductive Harm-www.P65Warnings.ca.gov

Price: 249 USD

Location: Glendale, California

End Time: 2024-11-14T17:52:57.000Z

Shipping Cost: 0 USD