Rear Pair Air Suspension Springs For Lincoln Mark VIII LSC 1993-1998

Description: *Compatibility Chart 1, You can distinguish specific model of an automobile by VIN(Vehicle Identification Number). 2, VIN(Vehicle Identification Number) consists of total 17 English letters and arabic digits. 3, VIN does not include the letters I (i), O (o), and Q (q) (to avoid confusion with numerals 1 and 0). Lincoln Mark VIIIAnniversary Sedan 2-Door 4.6L 1996Base Coupe 2-Door 4.6L 1995-1996Base Sedan 2-Door 4.6L 1993-1998LSC Sedan 2-Door 4.6L 1995-1998 *Generation & Evolution: Lincoln Mark SeriesFirst generation (Mark II,1956-1957) Successor (Mark III, Mark IV, Mark V;1958-1960)Second generation (Mark III,1969-1971)Third generation (Mark IV,1972-1976)Fourth generation (Mark V,1977-1979)Fifth generation (Mark VI,1980-1983)Sixth generation (Mark VII,1984-1992)Seventh generation (Mark VIII,1993-1998) *Platform Drive Layout: Front Engine-Rear Wheel Drive Layout *Removal Guideline:Caution: Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified in the instructions or in a different sequence.1.To avoid the possibility of short circuits while working with electric components consult your owners manual on how to disconnect your battery.2.Consult your vehicle owners manual, service manual, or car dealer for the correct jacking points on your vehicle and for additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath the vehicle if it is not adequately supported, as serious injuries and death can occur. 1.Turn the air suspension switch to the off position.(switch is located on the driver side of the luggage compartment.)2.Raise the vehicle.3.Remove the rear wheel and arch liner.4.Remove air spring solenoid retaining clip.5.Rotate solenoid counter-clockwise to the first stop, and then carefully pull down to vent the air pressure from the air spring. After air spring is deflated, turn again and remove solenoid from air spring.6.Depress the four plastic locking finger clips in bottom of air springs piston to unclip air spring from the lower suspension arm. *Installation Guideline:1.Replace the O-rings on the air spring solenoid and lubricate.2.Install solenoid, and replace solenoid retaining clip.3.Replace the top air spring retaining clip.4.Insert the air springs upper cap into the two holes in chassis and twist to lock back into place. The rear air spring will fit in either RH or LH.5.Insert the plastic locking fingers of lower piston into lower suspension arm. Make sure they are locked in place. You need to visually verify that all of the four plastic fingers are correctly retained.6.Replace the tire and wheel assembly. Tighten wheel hub bolt nuts to manufactures specifications. Remove all safety stands and lower vehicle.7.Partially lower the rear suspension. Do not lower to the bump stops.8.Turn the air suspension switch to the on position.9.Start the engine and let the air suspension rise to normal trim height. *Removal Warning & Notice: Vent all air pressure from the air suspension system prior to disconnecting or removing any air suspension components. It is dangerous to remove air suspension components while under pressure. Failure to follow this instruction may result in serious personal injury. Any air spring which is unfolded must be refolded prior to being installed in a vehicle. Refer to the procedure. An incorrectly folded air spring could rupture, altering the handling characteristics of the vehicle. If a vehicle has been driven with an incorrectly folded air spring, a new air spring must be installed. Failure to follow these instructions may result in serious injury to vehicle occupant(s). Failure to observe the following instructions may result in a sudden failure of the air spring or suspension system. Any rear spring which is unfolded must be refolded prior to being installed in a vehicle. The air spring refolding procedure should only be used for an air spring which has never supported the vehicles weight while in the incorrectly folded position. Incorrectly folded air springs found on vehicles during pre-delivery inspection or after use must be installed new. Do not attempt to inflate any air spring which has been collapsed while uninflated from the rebound hanging position to the jounce stop. When installing a new air spring, care must be taken not to apply a load to the suspension until springs have been inflated using the air spring fill procedure. After inflating an air spring in the hanging position, it must be inspected for correct shape.1.NOTE: The vehicle must be positioned on a suitable lifting device prior to deflating the air suspension system.With the vehicle in NEUTRAL, position on a hoist until the wheel and tire assemblies are slightly above the ground. 2.Using the scan tool, vent the air springs.3.Remove the air spring retainer.4.Detach the air spring from the rear axle. 5.Remove the air spring in the following sequence. 1.Disconnect the air spring solenoid electrical connector. 2.Compress the quick connect locking ring and pull out the air tube. 3.Remove the air spring. *Frequently Asked Questions:How to prevent the damage of air springs/How to extend the service life of air springs/struts etc.?An air strut with separable air springsIf your vehicle offers a separable air suspension (Audi Allroad A6 C5, Mercedes-Benz W164, BMW X5, etc.), you should regularly (about once a week) lift the car to the maximum position, and remove dirt with a high-pressure cleaner (keep the cleaner at a distance to the air spring about 30 cm/12 inches, otherwise water pressure can damage the air spring). The highest position may vary depending on your model and regulation options. Therefore, please test this by trying the different modes available to you (Sport, comfort, dynamic, off-road) and choose the one that sets your vehicle to the highest position. The dirt will most likely be found under the fold of the pneumatic chambers. If you find a frozen layer of bitumen on the piston guide (the part of a strut on which the air spring is installed), it is recommended to clean it as well. Whenever possible, avoid riding on fresh asphalt, as fresh bitumen mixed with sand immediately results in a build-up of abrasives on the piston and in turn contributes to accelerated wear and tear of the air spring. A complete air suspension shockMany cars such as Mercedes W220 or W211 are set up with a complete air strut - shock absorber and air spring visually form a complete spare part. In many cases, you can easily recognize these by the metal cups with which the air spring is tightly mounted. To best avoid any damage, we highly recommend to regularly check the condition of the dust protection seals of the air strut. What is the difference between an air spring and an air strut? The air spring is a part of the air strut. Some vehicles (e.g. Mercedes ML) allow you to change the air spring separately. At our online shop you have the opportunity to buy either the whole air strut or only the air spring. For some type of vehicles it is not possible to change the air spring separately. In this case the whole air strut should be replaced. Which side of my car is the Right and Left? The right and left sides of an automobile are determined as if sitting in the car facing forward. Thus, the left side is on the left when sitting in the car facing forward, and the right side is on the right. For American cars, the driver’s side is on the left, and the passenger sits to the right of the driver. For cars in Japan, Britain, Ireland, the Bahamas and some other former British colonies -- where they drive on the left side of the road -- the passenger sits on the left side, and the driver (along with all the driving controls) is on the right. *OEM Part Number: 3U2Z5580FA *Item Specifications:Key Words: Rear Pair Air Suspension Spring Bags For Lincoln Mark VIII 1993-1998Package Includes: Pair for Rear Left & Right Air Suspension Spring Bags Notes: Please double confim the compatibility as well as the OEM number before purchasing.Instruction is not included. Professional installation is recommended. Shipping WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. 1. Package handling takes about 2 business days at our warehouse, so please make sure entering correct payment and shipping information before checking out. Once your payment is completed, we are not going to accept any more changes to your order. 2.All domestic orders will be shipped via USPS, UPS or Fedex from our US warehouse and usually arrives to your door in about 2-7 business days. 3.Local pick up is not available. 4.International Buyers C Please Note: a. Import duties, taxes and charges are not included in the item price or shipping charges. These charges are the buyers responsibility. b. Please check with your country customs office to determine what these additional costs will be prior to bidding/buying. ] Payment 1.We accept multiple payment methods, such as PayPal, VISA, Master Card, etc.. 2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages. 3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.) 4.Payment must be received within 7 days as auction ended or order might be delayed. Returns 1.All of our brand new items come with a 60-Days money-back guarantee. 2.We define the item as defective only if it doesnt function as described, It is the buyers responsibility to understand the item description before bidding. 3.We will replace the defective items, provided that they are in stock within the warranty period posted with the listing and the buyer return the original item and pay for the S&H cost for the replacement. 4.We will refund the purchase price if the replacement is not available or buyer prefers a refund and send the original item back at his/her own cost. 5.Shipping& handling cost are not refundable. 6.Man-made damage by abuse or wrong operation is not covered by this warranty. 7.No product liability insurance is assumed. 8.Refunds will be credited within 5 to 7 business days of receiving the return. When weve received and processed the return, we will refund the applicable amount minus any Recovery Fees (See Details Below) for the amount you paid for the item(s), plus any applicable sales tax. ] Customer Services Q: How do I pay for my purchase? A: MY store accepts PayPal, VISA, Master Card, etc.. Q: When will the item be shipped out? A: This item will be shipped with 2 business day once payment completed. Q: Where is my tracking number? A: Please log on your account, click "my eBay"-->"my summary", or open your email box and find the shipping notification email. Q: How do I return an item? A: My tore accepts returns. Items must be returned within 60 days. Refunds will be given as money back. Please contact our customer service before you return an item. ] Feedback 1. We will leave a feedback once we get your payment. 2. If you are dissatisfied for any reason, please do contact us a feedback. We will work hard to make sure EVERY CUSTOMER 100% SATISFIED and resolve any problem for you and always leave a feedback to all our customers. 3. If you are satisfied with the product you received, wish you can leave us a feedback. Copyright of SCITOO-AutoParts . All rights reserved.

Price: 72.34 USD

Location: Ontario, California

End Time: 2024-10-09T07:15:57.000Z

Shipping Cost: 0 USD